X133 and X156 Printers
E10 Printer and Parts
E6 Printer and Parts
The screen is a special SHARP screen for the EPAX X1 and X1-N 3D printer ONLY. Using this screen with any other similar LCD printers is not supported.
Since day one, all our 5.5 LCD screens have both SX04(internal default) and SX03 interfaces. The SX04 to SX03 converter is covered/hidden by black tape. To use the screen on EPAX X1-N printers, you will need to carefully remove the black tape on screen's cable to expose SX04 interface.
The screen has tempered glass installed on top. So even if you spill resin or have a small resin leak, you can gently remove the resin without damaging the screen. Do not leak resin under the screen through edges. It is strongly recommended that you cover the edges with our pre-cut screen tape or with 0.1mm thick kapton tape, if needed.
LCD Screen Specifications
EPAX X1 and X1-DJ use MIPI (SX03) interface.
EPAX X1-N and X1-N-DJ use MIPI (SX04) interface. X1-N and X1-N-DJ have a side window on metal body. You just need to open the window while replacing LCD screen. No need to open bottom panel any more.
Make sure correct interface is used for your printer.
Drive Board Specifications
For instructions showing you how to replace the screen of your X1, please see this video: https://youtu.be/_R3TH6wx3Cw
After replacing your screen, it is crucial that you also re-level your build platform.
LCD screens are consumed in this printing technology. As a result they are not covered by a warranty. Many screen failures are due to tiny residues in your resin vat between prints. The residues are pressed into the screen and lead to heated stress spots that cause the LCD crystal to burn out. Other times the residues can be large enough to crack the screen. Overly high exposure time settings over time will also decrease screen lifespans.
We guarantee that your screen will work upon arrival and following installation.