EPAX X1-4KS 6.6" Magnetic Build Plate and Steel Plate

This magnetic build plate is compatible with X1-4KS 6.6" printers. It is attached to the existing build platform of X1-4KS printers using an adhesive magnetic pad.  Does not come with the build platform itself. Not recommended for dental use.

You can choose the magnetic pad+steel plate or the steel plate by itself.

Two options to choose from:

1, Magnetic pad and Steel Plate

2, Steel Plate Only

Steps to apply:

1, Clean your existing Metal Build Platform well.  Make sure no IPA is left on the existing build surface since IPA can dissolve the glue of the magnetic pad.

2, Glue magnetic pad to the existing build platform.  The pad comes with glue pre-applied.

3, Put the steel plate on.

4, Re-level the new whole Build Platform similar to before.

Size: 5.75" x 3.625" (146mm x 92mm) 

Caution:

You can use IPA to clean the steel plate and magnetic pad surface.  But not to soak the magnetic pad in IPA.  Doing that will lead to the separation of the pad from the build platform since IPA can dissolve the glue. 

This magnetic build plate comes ready to install on your build platform quickly. After applying the magnetic pad and steel plate to your existing build platform, you must recalibrate your build platform because of the increased height of the build surface. Failure to relevel/recalibrate your build platform could result in damage to other parts such as the LCD screen. 

See the video below for how to level or re-level your build plate: